Filter Cleaner Engine Oil
Product code RXSOL-16-1095-025
Specialized to remove carbonized oils deposits and prevent coke-like deposits from engine equipment. Very usefull to clean fuels recipitation of paraffin and asphalt or with lubricating oils which can form solid encrustations on the mesh.
Description
Very usefull to clean Fuels precipitation of paraffin and asphalt or with lubricating oils mixing of different types of oil can form solid encrustations on the mesh. It is heavy duty emulsifying liquid , which is Extremely and effectively removes tenacious carbon deposits, burnt grease, Oily residues and lacquers , from fuel oil and lube oil purifiers, filters, separators. Effective cleaning of fine meshes is achieved by soaking in RXSOL-16-1095-025 followed by blasting with compressed air using a cleaning gun.
Application
Mechanical cleaning (scrubbing and brushing )damages the filter which results in poor performance .
Cleaning process and requirement of time depends on the type of the contamination. With fuels recipitation of paraffin and asphalt or with lubricating oils mixing of different types of oil can form solid encrustations on the mesh.
RXSOL-16-1095-025 can be undercooled or overheated during storage but remains fully usable when returned to normal temperature.
MESH CONTAMINATED WITH HEAVY OIL:
Elements contaminated with heavy oil must be soaked in a standard commercial aromatic solvent. After soaking the elements are cleaned by high pressure Cleaning Device using RXSOL-16-1095-025 solution.
INSTRUCTIONS FOR USE:
Use of RXSOL-16-1095-025 is not restricted to a particular method of cleaning. Depending on the operating conditions, RXSOL-16-1095-025 can be used in a dip bath, in a spraying plant, in steam jetting or in manual application using a cloth, brush or sponge. It can be used warm or cold. RXSOL-16-1095-025 is miscible with water - even seawater.
Concentration for mesh cleaning: 1 : 2,5
Temperature: up to a maximum of 60 °C
The concentration depends on the type and thickness of the adhesive substance to be removed. When used in concentration below 1 : 30 rinsing is usually not required. No visible film remains on the surface